Filter
Top Products
Page 7SKU 98113 For technical questions, please call 1-800-444-3353.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch to its
off position and disconnect
the Adapter Cord from its
electrical supply source
before performing any
inspection, maintenance, or
cleaning procedures.
Worklight Set Up
Always place the Worklight on a 1.
clean, dry, at, level surface capable
of supporting the weight of the Work-
light.
The work area must be free of direct 2.
sunshine and high temperature.
Keep children and pets out of the 3.
work area.
Route the AC/DC Adapter Cord (17) 4.
and Cigarette Lighter Adapter Cord
(16) along a safe route to reach the
work area without creating a tripping
hazard or exposing the Cords to pos-
sible damage. The Cords must reach
the work area with enough extra
length to allow free movement while
working.
General Operating Instructions
To Charge the Battery Pack Using the
AC/DC Adapter:
To charge the Battery Pack (12) of 1.
the Worklight, open the Charging
Socket Cover (11) on the tool and
insert the AC/DC Adapter Cord (17)
into the tool’s Charging Socket (7).
Make sure the Power Switch (10) is
in its “OFF” position throughout the
charging process. Then plug the AC/
DC Adapter into the nearest 120 volt,
grounded, electrical outlet.
IMPORTANT: 2. The initial charge time
for the Battery Pack is 10 hours.
Thereafter, the charge times are 6
hours. Do not overcharge the Bat-
tery to avoid damage to the Battery
and/or AC/DC Adapter.
The Battery Indicator Light on the 3.
Worklight will illuminate as follows:
Battery needs charging:• Right
side LED illuminates RED.
Battery is charging:• Left side LED
illuminates RED.
Battery is fully charged: • Left side
LED illuminates GREEN.
When nished charging, unplug the 4.
AC/DC Adapter from its electrical out-
let. Then unplug the Cord from the
Charging Input Port of the Worklight.
(See Figure A.)
FIGURE A
POWER SWITCH (10)
AC/DC ADAPTER
CORD (17)
OR
CIGARETTE LIGHTER
ADAPTER CORD
(16)
CHARGING SOCKET COVER
(11)