Filter
Top Products
Page 8SKU 98113 For technical questions, please call 1-800-444-3353.
To Charge the Battery Pack Using the
Cigarette Lighter Adapter:
Prior to recharging, allow the battery 1.
to cool completely.
To charge the Battery Pack (12) of 2.
the Worklight, open the Charging
Socket Cover (11) on the tool and
insert the Cigarette Lighter Adapter
Cord (16) into the tool’s Charging
Socket (7). Make sure the Power
Switch (10) is in its “OFF” position
throughout the charging process.
Then plug the Cigarette Lighter
Adapter into a 12 VDC vehicle ciga-
rette lighter receptacle.
IMPORTANT:3. The initial charge time
for the Battery Pack is 10 hours.
Thereafter, the charge times are 6
hours. Do not overcharge the Bat-
tery to avoid damage to the Battery
and/or AC/DC Adapter.
The Battery Indicator Light on the 4.
Worklight will illuminate as follows:
Battery needs charging:• Right
side LED illuminates RED.
Battery is charging:• Left side LED
illuminates RED.
Battery is fully charged: • Left side
LED illuminates GREEN.
When nished charging, unplug the 5.
Cigarette Lighter Adapter from its
lighter receptacle. Then unplug the
Cord from the Charging Input Port of
the Worklight.
(See Figure A.)
Turning the Worklight on and off:
To turn on the Worklight, press the 1.
Power Switch (10) to its “ON” posi-
tion. To turn off the Worklight, press
the Power Switch again to its “OFF”
position. (See Figure A.)
The Worklight is designed to operate 2.
(on a fully charged Battery Pack) for
approximately 6 hours before re-
charging is required.
When nished using the Worklight, 3.
make sure to store the tool in a clean,
dry, safe location out of reach of chil-
dren and other unauthorized persons.
MAINTENANCE AND
SERVICING
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Before performing any
inspection, maintenance, or
cleaning procedures:
Turn the Power Switch
(10) of the Worklight to its
“OFF” position. Unplug the
tool’s AC/DC Adapter (17) or
Cigarette Lighter Adapter (16)
from its electrical outlet. Then
allow the tool to completely
cool.
TO PREVENT SERIOUS
INJURY FROM EQUIPMENT
FAILURE:
Do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.