Filter
Top Products
SKU 98544 For technical questions, please call 1-800-444-3353. Page 13
Drill only as deep as necessary. Do
not drill deeper than necessary into
walls or other areas where you can-
behind the drilling surface.
To reduce jamming as the Bit breaks
through the workpiece, decrease the
drilling pressure when the point of the
Bit breaks through the workpiece.
When you have drilled the hole, 17.
remove the Bit from the hole while
the Cordless Drill is still running. This
prevents the Bit from getting caught
in the hole and causing damage.
Release Trigger to stop the Drill, put 18.
and remove the bit from the Drill.
CLEANING AND
MAINTENANCE
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION: Set the Direction
Lever (38) to the center locked
position and unplug the
battery from the tool before
performing inspection,
maintenance, or cleaning
procedures.
Do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.
BEFORE EACH USE,1. inspect the
general condition of the tool. Check
for loose screws, misalignment or
binding of moving parts, cracked or
broken parts, damaged electrical wir-
ing, and any other condition that may
affect its safe operation.
AFTER USE,2. clean external surfaces
of the tool with clean cloth.
BEFORE EACH USE,3. inspect the
general condition of the Cordless
Drill/Driver. Check for misalignment
or binding of moving parts, cracked
or broken parts, leaking Battery Pack,
damaged Charger wiring, chipped or
broken Drill Bits, and any other condi-
tion that may affect its safe operation.
If abnormal noise or vibration occurs,
have the problem corrected before
further use.
Do not use damaged equipment.
After each use: 4. With a soft brush or
cloth, remove all dirt and debris from
the Cordless Drill/Driver. Do not im-
merse the Cordless Drill/Driver in any
liquids.
The lithium battery in this tool 5.
must be recycled or disposed of
properly.