Chicago Electric Solar Shed Light Work Light User Manual


 
Page 4SKU 95573
For technical questions, please call 1-800-444-3353.
SPECIFIC SAFETY RULES
Maintain labels and nameplates on the Shed Light. These carry important infor-
mation. If unreadable or missing, contact Harbor Freight Tools for a replacement.
Maintain a safe working environment. Make sure there is adequate surrounding
workspace. Do not use this product in a damp or wet location. Do not set up the
Solar Shed Light if under the influence of alcohol or drugs. Read warning labels on
prescriptions to determine if your judgement or reflexes are impaired while taking
drugs. If there is any doubt, do not set up the Solar Light.
Keep the Solar Panel free of dirt, dust and grime. Dust covering the Solar Panel
will block out sunlight causing a decrease or stoppage of efficiency in recharging
the batteries.
WARNING: This product contains or, when used, produces a chemical known
to the State of California to cause cancer and birth defects or other reproduc-
tive harm. (California Health & Safety Code § 25249.5, et seq.)
WARNING: NiCd batteries must be disposed of properly. Do not incinerate.
Batteries may burst, causing personal injury and/or property damage. Contact your
local hazardous waste disposal authority for proper disposal.
UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
Note: For additional information regarding the parts listed in the following pages, refer to
the Assembly Diagram near the end of this manual.
WARNING! Make sure the Power Switch of this product is in its “OFF” position and
that the Solar Shed Light is unplugged from its electrical outlet before making any
adjustments to the tool.
Note: If the Light unit is passing from the outside to the inside of the Shed, take into con-
sideration the clearance needed for the Cord (10) and if the Light is to be mounted
for indoor lighting.
1.
2.
3.
4.
5.