Filter
Top Products
Chapter 2 Installation
Optional Installation Steps
2-16
Cisco 1711 and Cisco 1712 Security Access Routers Hardware Installation Guide
OL-4050-02
Figure 2-8 Assembling Stacking Clip and Fastener
After assembling the clip and fastener, follow these steps to stack the router with
another device:
Step 1 Place the clip on top of the lower device, as shown in Figure 2-9 on page 2-17.
Slide the clip forward so that the front tabs slide into the vent slots. Make sure that
the rear hooks fit over the edge of the lower device.
H11542
Push plastic fastener
through small hole
at the end of the
stacking clip.