Filter
Top Products
Chapter 2 Installation
Connecting Power to the Router
2-8
Cisco 1711 and Cisco 1712 Security Access Routers Hardware Installation Guide
OL-4050-02
Warning
This product relies on the building’s installation for short-circuit (overcurrent)
protection. Ensure that a fuse or circuit breaker no larger than 120VAC, 15AU.S.
(240VAC, 16A international) is used on the phase conductors (all
current-carrying conductors).
Warning
This equipment is intended to be grounded. Ensure that the host is connected to
earth ground during normal use.
Follow these steps to connect power to the router and to turn the router on:
Step 1 Connect the attached power-supply cord to the power socket (labeled +5, +12,
-12 VDC) on the router rear panel, as shown in Figure 2-4 on page 2-9.