Filter
Top Products
14
Other accessories, saw blades
Festool offers sawblades which are ideally matched to your
Festool jigsaw and application, to ensure quick and clean cuts
in a variety of materials.
The order numbers for these sawblades as well as for all other
accessories can be found in your Festool catalog.
Accessories, tools
For safety reasons, only use original FESTOOL
accessories and tools!
The accessory and tool order number can be found in your
FESTOOL catalog + Internet.
Festool guide system FS
The use of the Festool guide system FS facilitates the
production of straight and precise cuts, particularly with
material thicknesses up to 20 mm / 3/4. To do this, the
jigsaw is placed in a guide stop (13.1), order no. 490 031)
and guided along the guide rail.
The guide stop has two adjustable limit stops (13.2) for a
setting free from play.
Maintenance and care
Any maintenance or repair work requiring the
motor housing to be opened may only be carried out by an
authorized service workshop. Maintenance or repair work
carried out by an unauthorized person can lead to the wrong
connection of the power leads or other components, which in
turn can lead to accidents with serious consequences.
Always remove the plug from the mains supply
socket before carrying out any work on the machine!
Always keep the machine and the ventilation slots clean.
Parallel guide
Use the parallel guide (order no. 486 719) to guide the jigsaw
parallel to the workpiece edge.
The parallel guide can be fitted on both sides of the base
runner:
- Turn off and unplug tool.
- Slide clamping clip (14.2) onto the base runner from the
front.
- Insert parallel guide (14.3) through the clamping clip from
the side to the desired position.
- Tighten rotary knob (14.1).
Circle cutter
circular cuts with a diameter between 120 mm and 720 mm
(4.7-28.3).
The circle cutter can be fitted to either side of the base runner:
- Turn off and unplug tool.
- Slide clamping clip (15.2) onto the base runner from the
front.
- Insert circle cutter (15.3) through the clamping clip from the
side to the desired position.
- Tighten rotary knob (15.1).
- Insert circle tip (15.4) in the rear bore hole of the circle
cutter.