Compatible Systems 2250R Router User Manual


 
Chapter 6 - Basic Configuration Guide 21
Suggested for IPX
You may want to set your own network numbers, rather than using the
autoconfigured values. You may also want to turn off unused frame
types.
CV: Use the IPX Routing: Ethernet 0 Dialog Box.
TB:Useconfigure and set keywords in the IPX Ethernet 0 section.
AppleTalk Protocol
Required for AppleTalk
There are generally no required changes from the shipping Ethernet
configuration for AppleTalk. The Ethernet interface will autoconfigure
to use AppleTalk Phase 2, and will autoadapt to conditions on the
Ethernet.
Suggested for AppleTalk
You may want to set your own network numbers, rather than using the
autoconfigured values. You may also want to use more meaningful
zone names.
CV: Use the AppleTalk Routing: Ethernet 0 Dialog Box.
TB: Use configure and set keywords in the AppleTalk Phase 2
Ethernet 0 section.
DECnet Protocol
Required for DECnet
The router’s shipping configuration does not have DECnet turned on.
You must turn it on and set several DECnet parameters.
Set DECnet on (globally, and for this port)
Set DECnet area
Set DECnet node
CV: Use the DECnet Routing Dialog Box (under Global/DECnet
Routing) and the DECnet: Ethernet Dialog Box.
TB: Use configure and set the Enabled, Area,andNode keywords in
the DECnet Global section.
Note: Setting DECnet on for any port with the command line also
sets DECnet on globally. In CompatiView you must set a global
parameter and a port-specific parameter.