Filter
Top Products
Appendix B-1 (7)
Length Softkey
By pressing the soft key located under the word Length on
the Main Screen, the preset for the Length counter is
available.
The number shown is the current length preset value, i.e.
the length to cut the product. A cursor will appear in the
least significant digit. The user has a choice of ways to
adjust this number.
Exit or Prev- if no change is required press Exit or Prev to
return to the Main screen.
Raise will increase the preset by 0.01”. The key can be
pressed once for each 0.01” increment required or held
down to scroll up. Releasing the key will freeze the preset
at the last value.
Lower will decrease the preset by 0.01”. The key can be
pressed once for each 0.01” decrement required or held
down to scroll down. Releasing the key will freeze the
preset at the last value.
Numeric keys
Key in the length required and press enter. The decimal
place is fixed so remember this when entering the preset. If
you require 24 inches you must key in 24000 and then
press enter. Keying only 24 will set the length to 0.024
inches.
Enter or Delete?
If the keyed in number is correct press the enter key for it
to be accepted and return to the Main screen. If it is wrong
press the delete key and the previous preset will reappear.
LENGTH 0000.000 in.
Exit
Conair Servo
Traveling Saw
Operator Control
Instructions