Filter
Top Products
MOUNTING THE MITER SAW (FIG, O)
To avoid injury from unexpected mew movement:
, Before moving the saw, disconnect the power cord
from the outlet, and !ock the cutting arm in the lower
position using the stop latch.
NOTE: The stop latch is for carrying or storing the tooL
It is not to be used for holding the saw while cutting.
Lower blade and press in stop latch to secure saw for
transport or storage.
Never carry the miter saw by the power cord or by
the switch handle. Carrying the tool by the power
cord could cause damage to the insulation or wire
connections resulting in electric shock or fire.
To avoid injury from flying debris, do not allow visitors
to stand behind the saw.
Place the saw on a firm, level work-surface where
there is room for handling and properly supporting
the workpiece.
Support the saw on a leve! work surface.
Bolt or clamp the saw to its support.
Place the saw in the desired location, either on a work
bench or recommended leg seL The base of the saw
has three mounting holes (1).
For etetionery use, fasten the saw to a workbench.
For po_ebte uee, fasten the saw to a 3/4 in. piece of
plywood. This mounting board can then be clamped to a
secure surface.
Fig. 0
Portable Use
Stationery Uee
Hand Hold
3/4 Inch Plywood
15