Filter
Top Products
22 23
22 23
Fig. Z
Bevel/Miter Settings
Fig. AA
Settings for standard crown molding lying flat on
compound miter saw table
Miter Saw Table
F
e
n
c
e
IL
IR
OL
OR
Outside Corner
Inside Corner
In order to accurately cut crown molding for
a 90° inside or outside corner, lay the molding
with its broad back surface flat on the saw table.
When setting the bevel and miter angles for
compound miters, remember that the settings are
interdependent; changing one changes the other,
as well.
NOTE: The chart below references a
compound cut for crown molding ONLY
WHEN THE ANGLE BETWEEN THE WALLS
EQUALS EXACTLY 90°.
KEY
BEVEL
SETTING
MITER
SETTING
TYPE OF CUT
Inside corner-Left side
IL 33.9° 31.6° Right 1. Position top of molding against
fence.
2. Miter table set at RIGHT 31.6°.
3. LEFT side is finished piece.
Inside corner-Right side
IR 33.9° 31.6° Left 1. Position bottom of molding
against fence.
2. Miter table set at LEFT 31.6°.
3. LEFT side is finished piece.
Outside corner-Left side
OL 33.9° 31.6° Left 1. Position bottom of molding
against fence.
2. Miter table set at LEFT 31.6°.
3. RIGHT side is finished piece.
Outside corner-Right side
OR 33.9° 31.6° Right 1. Position top of molding against
fence.
2. Miter table set at RIGHT 31.6°.
3. RIGHT side is finished piece.