Filter
Top Products
TO CHECK DEPTH OF CUT
a. Place a straight edge on the outfeed table extending over the infeed
table.
b. Measure from the surface of the infeed table to the bottom of the
straight edge. This will be the depth of cut.
NOTE: This Jointer-Planer will make a maximum 118" deep cut. To reduce
THE DANGER of kickback and possible injury, the depth of cut should not
exceed 1/16" when cutting wood wider than 1.1t2".
,_CAUTION: MAKE SURE THE SWITCH IS OFF AND THE CORD IS
UNPLUGGED BEFORE PERFORMING THIS CHECK.
OUTFEED
TABLE
MAX. DEPTH
.OF CUT 1/8"
m
FENCE ADJUSTMENT
The fence can be adjusted to cut angles from O° to 45 °. Stop pins
allow automatic setting to 0°, 221/2=, 30 ° or 45 ° in either the inboard
or outboard direction.
TO ADJUST: Loosen fence lock knobs and lift the stop pins out and
turn to lock out. Move the fence to the desired angle. If It is one of the
commonly used angles listed above, release the stop pins and they
will pop into place when the correct angle is reached. Tighten the
fence lock knobs to lock the fence in place. Fora less common angle
or to fine tune to an angle less than the 5 ° divisions on the fence seg-
ment. Pull and lock out the stop pins and use the 0 ° to 5 ° scale on the
tilt indicator to set the exact angle desired.
1. FOR OUTBOARD TILT add the reading on the tilt indicator to the
reading on the fence segment.
2. FOR INBOARD TILT subtract the tilt indicator reading from the
reading on the fence segment. Always tighten the lock knobs to
maintain the desired setting.
45° INBOARD
8TOP
TILT
INDICATOR
FENCE
O °
3. CUTTER GUARD
The cutter guard provides protection over the cutter head, It must
always be in place and functioning properly.
Check the guard to make sure it is functioning properly.
a. Pass a 114" thick piece of wood over the cutter head between the
guard and fence. The guard must return automatically.
b. Open the cutter guard all the way until it stops and release
it several times. It should always return to its original
position.
,_ CAUTION: IF THE CUTTER GUARD FAILS TO OPERATE
PROPERLY, THE CUTTER GUARD RETURN SPRING
WILL NEED REPLACING. CONTACT YOUR NEAREST
SEARS STORE OR SERVICE CENTER FOR REPLACE-
MENT SPRING AND INSTRUCTIONS BEFORE USING
THE JOINTER-PLANER.
4. GUARD STOP
The Craftsman Jointer/Planer comes equipped with a cutter guard
stop assembly to improve safety and reduce risk of injury. Be sure to
read and understand all instructions in the ASSEMBLY and BASIC
JOINTER/PLANER OPERATION sections before operating this tool.
5. ON.OFF SWITCH
The operating positions of the "On-Off" switch are located on the
front of your Jointer-Planer. Push the switch up to turn your Jointer-
Planer "on" and down to turn your Jointer-Planer "off". The switch
has a switch key which, when removed, allows the switch to be lock-
ed in the "off" position. To activate the locking feature push switch
to "off" position and pull switch key.
To turn Jointer-Planer "on" after it has been locked in the "off" posi-
tion, the switch key must be replaced in the switch.
WARNING: BE SURE SWITCH IS IN THE "OFF" POSITION
BEFORE PLUGGING JOINTER-PLANER INTO POWER SOURCE
FAILURE TO DO SO COULD RESULT IN ACCIDENTAL
STARTING CAUSING SERIOUS INJURY.
_swiT'c H KEY
SWITCH