Filter
Top Products
10
WORK LIGHT (Fig. H)
The Bench Grinder is provided with a Flexible Work
Light to assist in visibility of the workpiece.
The Bench Grinder is NOT provided with a light bulb for
t
he Flexible Work Light.
To reduce the risk of fire, use a 120V, 40 watt Type A or
smaller bulb, medium base. DO NOT use a light bulb
that extends past the end of the light housing.
The Flexible Work Light (A) may be turned “ON” or
“OFF” by using the rotary switch (B) on the top surface
of the housing. The switch can be rotated in the clock-
wise direction only.
NOTE: The Flexible Work Light can be turned “ON” or
“OFF” even if the Bench Grinder is turned “OFF”.
CAUTION: The Flexible Work Light housing will remain
hot for a few minutes after turning it “OFF”. Avoid con-
tact with housing until it is cool.
Fig. H
B
A
WARNING
!
PERMANENT MOUNTING
Y
ou should firmly attach the Bench
Grinder to a solid work
surface or heavy-duty stand (hardware not included).
If the Bench Grinder is not securely mounted, it will
have the ability to move or tip over during grinding
operations and possibly cause the operator
’
s fingers to
contact the grinding wheels.
WARNING
!
EYE SHIELDS (Fig. G)
1. Remove both Eye Shield Assemblies from the plas-
t
ic bags and check to see that you have the follow-
ing. Eyeshield (qty. 2) Lock Knob (qty. 2) Spacer
(
qty. 2) M6 Flat washer (qty. 2) M6 x 80mm carriage
head screw (qty. 2)
2. Assemble the Eyeshield (C) to the Spark Arrestor
(A) by inserting the carriage head screw (B) through
Eyeshield (C), Spark Arrestor (A), and the spacer
(D) as shown.
3. Assemble the flat washer (E) and Lock Knob (F) to
the carriage head screw and tighten until the
Eyeshield remains in the desired position.
QUENCH TRAY
1. The Quench Tray is provided to cool the workpiece
during and after grinding operations.
2. Attach the Quench Tray to base of the Bench
Grinder as shown.
3. Tighten the two screws.
4. Partially fill the Quench Tray with water. DO NOT
overfill! DO NOT use any other liquid in the Quench
Tray other than water.
5. Place the workpiece into the water after performing
the grinding operation to cool it.
6. DO NOT put any water directly onto the grinding
wheels.
Fig. G
E
C
A
F
B
D