Filter
Top Products
ATrACHING VAC HOSE TO THE DUAL DUST PORT ADAPTER cont.
NOTE: A standard 11/4-in. vac hose connection fits i,lside the smaller diameter J
hole inside the dual dust port adapter, while a standard 21/2-in. vac hose
I
connection fits inside the larger hole of the dual dust port adapter
/_ WARNING: When sander is not connected to vacuum, always install the
Cyclonics dust box back on sander. Failure to do so could cause sanding dust
or foreign objects to be thrown into the face or eyes, which could result in
possible serious injury.
Z_ WARNING: Collected sanding dust from sanding surface coatings
(polyurethane, linseed oil, etc.) can self-ignite in sander dust box or elsewhere
and cause fire. To reduce risk, empty dust box frequently and strictly follow
sander manual and coating manufacturer's instructions.
/_ CAUTION: When working on metal surfaces, DO NOT use the dust box
or a vacuum cleaner because sparks are generated. Wear safety glasses and
a dust mask. Due to the danger of fire, do not use your sander to sand
magnesium surfaces. Do not use for wet sanding.
Before attempting to use any tool, be sure to familiarize yourself with all the
operating features and safety instructions.
/_, WARNING: IF ANY PARTS ARE MISSING, DO NOT OPERATE YOUR
SANDER UNTIL THE MISSING PARTS ARE REPLACED. FAILURE TO FOLLOW
THIS RULE COULD RESULT IN SERIOUS PERSONAL INJURY.
I Z_ WARNING: DO NOT let familiarity with your sander make you careless. I
Remember that a careless fraction of a second issufficient to cause severe injury.
ON/OFF ROCKER SWITCH (see Fig. 6)
This switch issealed to help keep out dust
for a longer life and is conveniently located
near the front of the palm grip handle.
Start the sander by pushing in the part of the
switch with the [----].Let the motor build to its
maximum speed before starting sanding
operation. To turn sander off, push side of
switch with the [].
16