Filter
Top Products
12
13
DESCRIPTION cont.
PRODUCT SPECIFICATIONS
Rating
Input
Rotary Drilling (No-load Speed)
Hammer Drilling (No-load Speed)
Chuck
120 Volts, 60 Hz AC
8.0 Amps
0-2800 / min. Variable Speed
0-44,800 / BPM (blows per minute) Impact rate
1/2-in. Keyed
VARIABLE SPEED TRIGGER SWITCH (Fig. 3)
The variable speed trigger switch controls the
variable speed in either the rotary drilling or
hammer drilling modes.
The drill delivers higher speed and torque with
increased pressure on the trigger switch and lower
speed and torque when the pressure is decreased.
To start the hammer drill, press the trigger switch.
To stop hammer drill, release the trigger switch.
OPERATION
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is sufficient to inflict serious injury.
!
WARNING: Always wear safety goggles or safety glasses with side shields
when operating power tools. Failure to do so could result in objects being
thrown into your eyes, resulting in possible serious injury.
!
Fig. 2
Variable Speed
Trigger Switch
Rear Handle
with Soft Grip
Depth
Stop Rod
Fig. 3
10-Ft. Power Cord
Auxiliary
Handle
Keyed Chuck
Bubble Level
This Hammer Drill has the following features: cont.
14. Metal Gear Box and Die-Cast Aluminum Gear Housing
For durability and long life. Helps protect tool from damage
15. High Impact-Resistant Housing
Helps protect tool from damage and reduces weight
16. Permanently Lubricated 100% Ball Bearings
For smooth operation and long life
17. Impact Resistant Case
For easy carrying and convenient storage of drill and accessories
Power Lock-on
Button
Chuck Jaws
Forward
Reverse Lever
Live Tool Indicator
Spindle Lock
Drill / Hammer
Mode Selector Switch
ROTARY AND HAMMER DRILLING MODE SELECTOR SWITCH (Fig. 4)
Always have the trigger switch in the OFF
position when operating the mode selector
switch.
To select the rotary or hammer drilling mode:
1. Press in the end of the selector lever and
rotate so the lever points to either the
rotary drilling symbol
or the hammer drilling symbol .
2. When the lever is pointing to the mode you
selected, you will feel it click in on the
selection, and the drill will now operate in
your selected mode.
Fig. 4
6
7
NOTE: You might hear a whistling or ringing noise from the trigger switch during
low speed use. Do not be concerned; this is a normal part of the switch function.
NOTE: The selector switch must be in either the rotary or hammer drilling modes
at all times; there are no operable positions between the two modes.