Craftsman 315.111450 Cordless Drill User Manual


 
RULES FOR SAFE OPERATION (CONTINUED)
!4,. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see thdt
keys and adjusting wrenches are removed from tool before turning it on,
15. NEVER USE IN AN EXPLOSIVE ATMOSPHERE_ Normat sparking of the motor could
ignite flammable liquids, gases or fumes,
t6 KEEP HANDLES DRY, CLEAN, AND FREE FROM OIL AND GREASE. Always use a
clean cloth when cleaning.. Never use brake fluids, gasoline, petroleum_based
products, or any strong solvents to clean your tool,
17. STAY ALERT. Watch what you are doing and use common sense, Do not operate
tool when you are tired. Do not rush°
t8. CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that
is damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting, and any other conditions that may affect
its operation. A guard or other part that is damaged should be properly repaired or
replaced by an authorized service center,
19, DO NOT USE TOOL IF SWITCH DOES NOT TURN IT ON AND OFF, Have defective
switches replaced by authorized service center°
20, DRUGS, ALCOHOL, MEDICATION. Do not operate _ooI while under the influence of
drugs, alcohol, or any medication_
21. CUTTING, DRILLING, OR DRIVING SCREWS INTO ELECTRICAL WIRING IN
WALLS, CEILINGS, OR OTHER AREAS CAN CAUSE BLADE, BIT, OR CHUCK TO
BECOME ELECTRICALLY LIVED Grasp only the insulated handle(s) or plastic
housing when using the tool
22 WEAR HEARING PROTECTION DURING EXTENDED PERIODS OF OPERATION°
IMPORTANT SAFETY RULES FOR BATTERY TOOLS
23 Battery tools do not have to be plugged into an electrical outlet, therefore they are
always in operating condition., Be aware of possible hazards when not using your
battery tool or when changing accessories°
24. USE ONLY THE CHARGER PROVIDED WITH YOUR BATTERY TOOL. Do not
substitute any other charger. Use of another charger could cause batteries to ex-
plode causing possible serious injury.
25 DO NOT PLACE BATTERY TOOLS OR THEIR BATTERIES NEAR FIRE OR HEAT.
They may explode°
26 DO NOT CHARGE BATTERY TOOL IN A DAMP OR WET LOCATION°
27. Your battery tool shoutd be charged in a location where the temperature is more
than 50°F but less than 100"F.
28 Under extreme usage or temperature conditions, battery leakage may occur, if liquid
comes in contact with your skin, wash immediately with soap and water, then
neutralize with lemon juice or vinegar. If liquid gets in your eyes, flush them with
clean water for at _east 10 minutes, then seek immediate medical attention.
29, If carrying your battery tool at your side, make sure it is not running and your finger
is not on the switch, Avoid accidental starting.
30 SECURE WORK before applying power. NEVER hold workpiece in your hand or
across your legs.
31, SAVE THESE INSTRUCTIONS. Refer to them frequently and use them to instruct
third party user° If you loan someone this tool, loan them these instructions also_
Page 3