Filter
Top Products
BATTERIES
OPERATION
Your ddtl is equipped with 5 nickel-cadmium
rechargeabte batteries Length of service from each
charging will depend on the type of work you are do-
ing
'[he nickel,.cadmium batteries in this tool have been
designed to last for the life of the unit under normal
operating conditions. Therefore, do not disassemble
your drill and attempt to replace them, Handling of
these batteries, especially when wearing rings and
jewelry, could result in a serious burn
WRIST STRAP
A wrist strap ts provided to reduce the chances of
dropping your drill, Place one hand through wdst
strap when carrying your dr_il See Figure 4.
SWITCH
The switch on your drill is designed for single speed
drilling For normal drilling operatfon, depress the
switch trigger atl the way.
REVERSIBLE
Your dri!l has the feature of being reversible The
direction of rotation is controlled by a selector
located above the switch trigger. See Figure 2. With
your drill he{d in normal operating position, the
direction of rotor{on selector should be positioned to
the left of the switch for drilling The drill direction Is
reversed when the selector is to the right of the
switch When the selector is in center position, the
switch trigger Is locked,,
TO PREVENT GEAR DAMAGE,
ALWAYS ALLOW THE CHUCK ON YOUR DRILL TO
COME TO ACOMPLETE STOP BEFORE CHANGING
THE DIRECTION OF ROTATION.
To stop your drill release switch trigger and allow
your drill to come to acomplete stop.
NOTE: To lock switch trigger, place the direction of
rotation selector in center position. See Figure 2
CHUCK KEY
A chuck key has been packed with your drill for use
when installing or removing bits tt is also used when
removing the chuck See Figure 3
CHUCK KEY STORAGE
When not in use the chuck key can be placed in the
storage area located on the back of your ddt! See
Figure 3 Page 6
(Cont.)
REVERSE
SELECTC
SWITCH
TRIGGER
CHUCK KEY
FORWARD
POSITION
(LOCK,OFF)
Fig, 2
CHUCK KEY
STORAGE
Fig 3