Filter
Top Products
RULES FORSAFE OPERATION (Contlnued).
An extension cord should not be used Unless,
absolutely necessary. Use of improper
extension cord could result in a risk of fire and
electric shock. If extension cord must be used,
make sure:
a. That pins on plug of extension cord are the
same number, size and shape as those of
plug on charger.
b. That extension cord is properly wired and in
good electrical condition; and
c. That wire size is large enough forAC
ampere rating of charger as specified
below:
Cord Length (Feet) 25ft. 50ft. 100ft. 150ft.
Cord Size (AWG) 16 16 16 14
Note: AWG = American Wire Gage
m DO NOT OPERATE CHARGER WITH A
DAMAGED CORD OR PLUG. If damaged, have
replaced immediately by a qualified serviceman.
• ' Do not operate_charger if ithas receive_a
sharp blow, been dropped, or otherwise
damaged in any way; take itto a qualified
serviceman.
Do not disassemble charger; take itto a
qualified serviceman when service or repair is
required. Incorrect reassembly may result in a
risk of eleotdc shock or fire.
M
To reduce dsk of electric shock, unplug charger
from outlet before attempting any maintenance
or cleaning. Tuming off controls will not reduce
this dsk.
• Do not use charger outdoors.
• Disconnect charger from power supply when
not in use.
SAVE THESE INSTRUCTIONS. Refer to them
frequently and use them to instructothers who
may use this tool. If you loan someone this tool,
loan them these instructionsalso.
,_ Look for this symbol to point out important safety precautions. It means attention!H Your
safety is involved.
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your ddll-driver continuously, the batter-
ies in your battery pack will become hot. You should
let a hot battery pack cool down for approximately 30
minutes before attempting to recharge.
Note: This situation only occurs when continuous use
of your drill causes the batteries to become hot. It
does not occur under normal circumstances. Refer to
"CHARGING YOUR DRILL-DRIVER" for normal
recharging of batteries. Ifthe charger does not charge
your battery pack under normal cimumstances, return
both the battery pack and charger toyour nearest
Sears repair center for electrical check.
WARNING:
The operation of any power tool can result in foreign objects being thrown into your eyes,
which can result in severe eye damage. Before beginning power tool operation, always wear
safety goggles or safety glasses with side shields and a full face shield when needed. We
recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses
with side shields, available at Sears Retail Stores.
5