Filter
Top Products
TOINSTALLBATTERYPACK
• Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 3.
• Place battery pack in your drill. Align raised rib
inside drill with groove on battery pack. See
Figure 4.
BATI'ERY t
PACK
TO REMOVE BATTERY PACK
• Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 3.
• Locate latches on end of battery pack and
depress to release battery pack from your drill.
See Figure 4.
• Remove battery pack from your ddll.
KEYLESS CHUCK
See Figure 5.
Your new drillhas a keylesschuck. As the name implies,
you can hand tighten or release drillbitsinthe chuck
jaws. Grasp and holdthe collar ofthe chuckwith one
hand. Rotate the chuck bodywith yourother hand. The
arrowson the chuckindicate which directionto rotate
the chuck body in order to LOCK (tighten)or UNLOCK
(release) the drillbit.
DRILLBIT
UNLOCK CHUCK
(RELEASE) COLLAR
LATCHES
DEPRESSLATCHESTO
RELEASEBATTERYPACK
Fig. 4
• Make sure the latches on each side of your
battery pack snap in place and battery pack is
secured in drill before beginning operation.
CAUTION: When placing battery pack in your
_drill, be sure raised rib inside drill aligns with
groove on battery pack and latches snap in place
properly. Improper assembly of battery pack can
cause damage to internal components,
LOCK CHUCK
(TIGHTEN) BODY Fig. 5
_1= WARNING: Do not hold chuck body with one
hand and use power of the drill to tighten chuck
jaws on drill bits. Chuck body could slip in your
hand or _,our hand could slip and come in contact
with rotating drill bit.This could cause an
accident resulting in serious personal injury.
9