Filter
Top Products
REVERSIBLE
See Figure 3.
This tool has the feature of being reversible. The direction
of rotation is controlled by a selector located above the
switch trigger. With the drill held in normal operating
position, the direction of rotation selector should be
positioned to the left of the switch for drilling. The drilling
direction is reversed when the selector is to the right of
the switch. When the selector is in center position, the
switch trigger is locked.
VARIABLE SPEED
See Figure 3.
This toot has a variable speed switch that delivers higher
speed and torque with increased trigger pressure. Speed
is controlled by the amount of switch trigger depression.
This drill has an electric brake. When the trigger switch is
released, the chuck stops turning. When the brake is
functioning properly, sparks will be visible through the vent
slots on the housing. This is normal and is the action of the
brake.
Note: You might hear a whistling or ringing noise from the
switch during use. Do not be concerned, this is a normal
part of the switch function.
FORWARD/REVERSE/LOCK
SELECTOR REVERSE
TO INSTALL BATTERY PACK
See Figure 4.
• Lock switch trigger on the drill by placing the direction
of rotation selector in center position.See Figure 2.
• Place battery pack in the drill. Align raised rib inside
drill with groove on battery pack.See Figure 4.
• Make sure the latches on each side of your battery
pack snap into place and battery pack is secured in
drill before beginning operation.
_i= CAUTION: When placing battery pack in the drill, be
sure raised rib inside drill aligns with groove on
battery pack and latches snap in place properly.
improper assembly of battery pack can cause
damage to internal components.
BATTERYPACK
LATCHES
FORWARD
VARIABLESPEED
SWITCHTRIGGER
Fig. 3
,_ CAUTION: To damage, always allow
prevent
gear
chuck to come to a complete stop before changing
the direction of rotation.
_DEPRESSLATCHESTO
RELEASEBATTERYPACK
Fig. 4
REMOVE BATTERY PACKTO
• Lock switch trigger on the drill by placing the direction
of rotation selector in center position. See Figure 2.
• Locate latches on end of battery pack and depress to
release battery pack from the drill. See Figure 4.
• Remove battery pack from the drill.
To stop, release switch trigger and allow the chuck to come
to a complete stop.
10