Filter
Top Products
SPECIFICATIONS
Chuck
Motor
Switch
Gear Train
3/8 in. (10 mm) Keyless
14.4 Volt DC
Variable Speed
One Speed
No Load Speed
Clutch
Charger Input
Charge Rate
Torque
0-600/min.
24 Positions
120 V, 60 Hz, AC only
3-6 Hours
Maximum 100 in.lb.
Before using this tool, familiarize yourself with all operating
features and safety requirements. However, do not let
familiarity with the tool make you careless.
This new drill-driver is equipped with the following features.
See Figure 1.
KEYLESS CHUCK
This tool has a keyless chuck that allows you to hand tighten
or release drill bit in the chuck jaws.
SWITCH
The drill-driver has a conveniently located variable speed
switch.
SWITCH LOCK
The switch trigger can be locked in the OFF position. This
feature helps reduce the possibility of accidental starting
when not in use.
_ SCREWDRIVERBITS
RED
LIGHT
BATTERYPACK
VARIABLE SPEED
This toot has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
by the amount of switch trigger depression.
FORWARD/REVERSE SELECTOR
(DIRECTION OF ROTATION SELECTOR)
The drill-driver has a forward/reverse selector located
above the switch trigger.
BIT STORAGE
When not in use, bits provided with the drill-driver can be
placed in the storage area located on the rear of the motor
housing.
WRIST STRAP
A wrist strap is provided to reduce the chances of drop-
ping the drill-driver. Place one hand through the wrist
strap when carrying toot.
TORQUE
ADJUSTMENTRING
BIT STORAGE
KEYLESSCHUCK
SWITCH
TRIGGER
FORWARD
REVERSE
SELECTOR
BATTERYPACK
CHARGINGSTAND SHOWNINTOOL WRISTSTRAP Fig. 1
7