Filter
Top Products
WARNING: Always wear safety goggles or safety
glasses with side shields when operating this toot.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
,_ WARNING: Exercise caution when using this tool.
Careless actions, for even a fraction of a second, can
result in serious personal injury.
CHARGING BATTERY PACK
The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it at least 3 to 6 hours prior to use.
Note: Batteries wilt not reach full charge the first time they
are charged. Allow several cycles (drilling followed by
recharging) for them to become fully charged.
TO CHARGE
• Charge battery pack only with the charger and
charging stand provided.
• Make sure power supply is normal household
voltage, 120 volts, 60 Hz, AC only.
• Connect charger to power supply.
• Place battery pack in charging stand. Align raised rib
on battery pack with groove in charging stand. See
Figure 1.
• Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charging
stand.
• When properly connected, the red light on charging
stand will turn on.
• Note: If charger does not charge battery pack, return
battery pack, charger and charging stand to your nearest
Sears Repair Center for electrical check.
• After normal usage, 3 hours of charging time is
required to be fully charged. A minimum charge time of
3 to 6 hours is required to recharge a completely
discharged tool.
• The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
• Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
• When batteries become fully charged, unplug charger
from power supply.
_I_ WARNING: Battery tools are always in operating
condition. Therefore, switch should always be locked
when not in use or carrying at your side.
SWITCH
See Figure 2.
To turn the drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
SWITCH LOCK
See Figure 2.
The switch trigger can be locked in the OFF position. This
feature can be used to prevent the possibility of accidental
starting when not in use. To lock switch trigger, place the
direction of rotation selector in center position.
FORWARD/ REVERSE/ LOCK
SELECTOR REVERSE
\
FORWARD
VARIABLESPEED
SWITCHTRIGGER
Fig. 2
9