Filter
Top Products
DEPTH OF CUT ADJUSTMENTS
See Figures 4, 5, and 6.
We recommend that cuts be made at a depth not
exceeding 1/8 in. and that several passes be made to
reach depths of cut greater than 1/8 in.
• Unplug your router.
_1 WARNING: Failure to unplug your router could
result in accidental starting causing
serious injury.
• Place your router on a flat surface, loosen locking
knob, and turn depth adjusting ring until cutter is
inside subbase. See Figure 4.
TO
TIGHTEN
LOCKING
KNOB
TO
CUI"FERATZERO _.,._
DEPTHOFCUT Fig. 5
• Position your router so that the cutter can extend
below the subbase for desired depth setting.
See Figure 6.
DEPTH
ADJUSTING
RING
DEPTH
RING
INDICATOR
POINT
CUI"I'ER
INSIDESUBBASE ' SUBBASE Fig, 4
• Turn depth adjusting ring until tip of cutter touches
flat surface. Turn the depth indicator ring until the
zero lines up with the indicator point on the base.
Note: The depth indicator ring is also a zero reset
indicator when setting cutter at zero depth of cut,
then it becomes the depth adjusting ring.
See Figure 5.
CuI-rER EXTENDED
BELOWSUBBASE Fig. 6
Turn the depth adjusting ring to obtain the desired
depth of cut. The distance the cutter moves can be
read on the depth adjusting ring. Each mark on the
depth adjusting ring indicates 1/16 inch change in
depth setting. Indicator point is located on the
base.
• Tighten locking knob securely before operating
router.
8