Filter
Top Products
TOADJUSTDEPTHOFCUTFORPLUNGEBASE
ROUTERS
See Figures 8, 9, 10 and 11.
Follow these steps to adjust depth of cut for plunge
base reuters.
1. Unplugthe router.
WARNING: Failuretounplugthe tool couldresult
in serious injury due toaccidental starting.
2. Place the router on a flat surface.
3. Loosen the stop bar knob.
4. Unlock the plunge lock lever.
5. Plunge the router until the tip of the cutter touches
PLUNGE
STOP LOCK
BAR LEVER
KNOB
\
Fig. 8
the flat surface.
6. Lock the plunge locklever.
7. Move the stop bar down so that it touches the depth
stop.
8. Tighten the stop bar knob securely.
9. Set the depth indicatorto zero.
10. Loosen the stop bar knob.
11. Set the depth indicatorto the desired depth of cut.
Note: Each mark on the scale indicates 1/16 in.
(1.6 ram).
12. Tighten the stop bar knob securely.
13. Unlockthe plunge lock lever.
14. Positionthe routerso that the cuttercan extend
below the subbase for desired depth ofcut.
CUTTER
Fig. 9
Fig. 10
15. Plunge the router until the stop bar touchesthe
depth stop.
16. Lock the plunge lock lever to position the cutter at
the desired depth of cut.
Fig. 11
13