Filter
Top Products
_1= WARNING: To ensure safety and reliability, all
repairs -- with the exception of the externally
accessible brushes-- shouldbe performedby a
qualifiedservice technician at a Sears storeto
avoid riskof personal injury,
BRUSH REPLACEMENT
See Figure 36.
BRUSH
ASSEMBLY
BRUSH
CAP
BRUSH
CAP
BRUSH
ASSEMBLY
Fig. 36
Your saw has externally accessible brush assemblies
that should be periodically checked for wear.
Proceed as follows when replacement is required:
• Unplug yoursaw.
_WARN|NG: Failure to unplug your saw could
result in accidental starting causing serious
injury.
• Remove brush cap with a screwdriver, Brush
assembly is spring_oaded and willpop o_ when
you remove brush cap,
• Remove brush assembly.
• Check for wear. Replace both brushes when
either has less than 1/4 in, length of carbon
remaining, Do not replace one side without
replacing the other.
• Reassemble using new brush assemblies, Make
sure curvature of brush matches curvature of
motor and that brush moves freely in brush tube.
• Make sure brush cap is oriented correctly
(straight) and replace.
• Tighten brush cap securely. Do not overtighten.
28