Filter
Top Products
PROBLEM
The drill does Rot start
when trigger switch is
squeezed
Will not drill
Motor overheating
CAUSE SOLUTION
Check to be sure power
cord is connected to
power source and that
power source (outlet) is
operable
Check drill bit and chuck
jaws
Be sure cooling vents
are free from dust and
obstacles
Connect to power
source.
Confirm power source
(outlet)is operable
Replace drill bit if dull or
worn; tighten chuck jaws
to firmly secure drill bit
Clean, clear vents.
Do not cover with hand
during operation
17217 Manual Revised 09-0708 Page 15