Filter
Top Products
GENERAL MAINTENANCE
,_ WARNING" Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial solvents and may
be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
,_ WARNING; Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc., come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic, which may result in serious personal injury.
WARNING" Always wear safety goggles or safety glasses with side shields
during power-tool operation or when blowing dust. If the operation is dusty, also
wear a dust mask.
PROBLEM CAUSE
The router does not
work
The table surface is
not flat
SOLUTION
Insert router power cord
plug into a table outlet
The router is not plugged
into the table outlet.
The router-table cord is
Plug the router-table cord
not connected to a power into a power source
source
The Router switch is in Insert key and pull the
"OFF" position, switch to the ON position
Legs are not properly as-
sembled,
Check assembly directions
and securely tighten all
fasteners
Place router table on a flat,
Work surface is not flat.
level surface
The router can not Use a sub-base 6-7/8 in. in
be attached to the Sub-base is too large diameter or less.
table
28:$80Manual_Revlsed_07-O228 Page22