Filter
Top Products
• If this system is used with other dust collectors, the dust
collector must be rated at least 3W' (of water) static pressure
and 150 cfm at 2W' diameter. A reducer may be needed.
• This system is not intended to be used with a wet/dry vac.
DANGER:Do not use this dust collection system in a
flammable or explosive atmosphere. Do not use to collect
metal shavings or dust Consult National Fire Protection
Association (NFPA) standards before setting up a dust collec-
tion system, especially NFPA 664.
WARNING: Do not connect to dust collector until unit is
completely assembled.
CAUTION: improper connection of the equipment-grounding
conductor can result in a risk of electrical shock.
• Open blast gate of machine which will be used. Close all
other blast gates.
• Turn dust collector power switch to ON.
• Turn woodworking machine power switch to ON.
Refer to Figure 2.
WARNING: Turn dust collector switch off and remove plug
from power source outlet before maintaining your shop dust
collection system.
Clean inside the pipes, fittings and flexible hose using a portable
vacuum cleaner or manually remove large debris as needed.
Model 351.223130
Figure 2 - Replacement Parts Illustration for
Dust Collection System
3
8
0
© 2
7
5
7
9
KEY
NO.
1
2
3
4
5
6
7
8
9
10
11
A
A
A
PART NO.
23967.00
23968.00
23969.00
23970.00
23971.00
23972.60
23973.06
23974.60
23975.60
23976.66
23977.00
23964.66
23961.61
Not Shown
DESCRIPTION
2_/2x 24" Flexible Hose
Connector
45 ° Elbow - 2W'
2_/2x 22" Plastic Straight Pipe
Hanger
2V2" Plastic "T" Fitting
Blast Gate
2_/Z' Hose Clamp
2_/2x 72" Flexible Hose
Mounting Hardware Kit
Grounding Kit
ID/Warning Label
Operator's Manual
QTY.
1
12
2
4
8
3
4
10
4
1
1
1
1
4