Filter
Top Products
MOUNT DUST COLLECTOR ASSEMBLY TO WALL
Refer to Figure 4.
To mount dust collector assembly:
• Lift dust collector assembly and position slots in wall
brackets over installed anchored screws. Slide dust collec-
tor assembly down so that anchored screws rest in narrow
portion of slots.
NOTE: Mounting dust collector will be easier and safer if done
by two people.
• Tighten four screws using offset or short Phillips head
screwdriver.
Anchored Screw
Figure 4 - Mounting Dust Collector Assembly
ATTACH COLLAR
Refer to Figure 5.
Collar needs to be attached to lower flex-ring of filter. To
attach lower collar:
• Pull filter down from dust collector housing.
• Make sure that filter is straight and there are no folds or
creases.
• Bend and insert lower flex-ring of filter into upper collar
channel.
• Pull down on collar to make sure that flex-ring is entirely in
channel.
_Housing Channel
_0_ ._r__(Inner)
j'-Cut-awayviewof
_/ _// Upper Housing
Loop
/ i'_"-" Filter
Upper Flex-ring _ y)
_Upper Collar
/" -_[_- ,Channel (Inner)
Lower Flex-ring __
_[_//Collar
.... \Lower Collar
Figure 5 - Attach Collar Channel (Outer)
ATTACH COLLECTOR BAG
Refer to Figure 6.
Collector bag needs to be attached to collar using collector
bag clamp. To attach collector bag:
• Remove collector bag clamp from collar.
• Slide collector bag over collar. Position bag approximately
2W' above lower edge of collar.
NOTE: The bottom of collector bag should rest flat on the
floor, so that the floor supports the weight of wood dust and
chips.
• Position bag clamp in lower channel of collar over bag.
• Position the spring connector into one of the slots on the
latch and lock the clamp handle.
• Make sure collector bag is secure.
NOTE: The top of collector bag should NOT block the filter. If
collector bag does block filter, fold excess bag over bag
clamp.
Collector Bag
Figure 6 - Attaching Collector Bag
4