Filter
Top Products
11
length with the pole saw standing
vertically. The top section of the pole
could descend rapidly and pinch your
hand.
PIVOTING THE SAW HEAD
The pole is designed to pivot at the top
end to allow the saw head to contact
branches in the most advantageous
position. To pivot the saw head,
squeeze the two black buttons at
the top of the pole (only the left side
button will actually depress), pivot the
saw head to the desired position, and
release the buttons to lock the saw
head in place. (see gure 18)
Figure 18
PRUNING WITH THE POLE SAW
HOLDING THE POLE SAW – Hold the
pole saw rmly with both hands when
the motor is running. Use a rm grip
with thumb and ngers of one hand
encircling the control handle, and the
thumb and ngers of the other hand
encircling the berglass pole. (see
gure 19)
Figure 19
USING THE POLE SAW – Always be
sure of your footing and hold the pole
saw rmly with both hands while the
motor is running.
NEVER STAND ON A LADDER –
Only operate the pole saw with both
feet planted rmly on the ground.
OVERHEAD ELECTRICAL LINES
– Never operate the pole saw within
50 feet of overhead electrical lines.
Failure to observe this precaution
could result in severe injury.
WARNING: KICKBACK may occur
when the nose or tip of the guide bar
touches an object, or when the wood
closes in and pinches the saw chain in
the cut. Tip contact in some cases may
cause a lightning fast reverse reaction,
kicking the guide bar up and back
towards the operator. Pinching the
saw chain along the top of the guide
bar may push the guide bar rapidly
back towards the operator. Either of
these reactions may cause you to lose
control of the saw which could result in
serious injury to user.
To Cut Branches From a Tree:
Make sure the saw is running before
attempting to make a cut.
Using light pressure make a cut on
the underside of the branch six inches
from the trunk using the top side of the
chain. This cut should be no deeper
than 1/3 the thickness of the branch.