Filter
Top Products
Rechargeable Power Pack Crestron ST-BTP
ST-BTP Installed into a Touchpanel (ST-1550C)
NOTE: The actual installation procedures for Crestron wireless
touchpanels other than the ST-1550C and its related family members are
provided in the Operations Guide of the touchpanel.
NOTE: This rechargeable power pack is shipped in a discharge
condition. Charge the ST-BTP in a well-ventilated area away from
sparks, flames, or smoking.
NOTE: The ST-BTP is a sealed power pack. Due to its sealed
construction, it can be charged or discharged in any position.
NOTE: The ST-BTP can be slow charged while in the battery
compartment of the touchpanel as long as the external power pack is
attached and plugged into an outlet. It takes approximately 24 hours to
trickle charge a fully discharged ST-BTP. There is no danger of over
charging the rechargeable power pack, so the ST-BTP can be installed at
all times. It only takes 2 hours to charge the ST-BTP in a Crestron
docking station, ST-DS.
1. Place touchpanel screen-side down on a clean and soft surface.
2. Place the designated end of the ST-BTP into the touchpanel
battery compartment. Refer to illustration on the next page.
4 • High Performance Rechargeable Power Pack: ST-BTP Operations Guide - DOC. 5746A