Filter
Top Products
19
touches the top of the gauge block. Tighten the nut
5. Repeat this adjustment with the gauge block on the
opposite end of the infeed roller.
1. Make sure the knives are adjusted properly as ex plained under How To Check, Adjust, And Re place Knives.
gauge. Tighten the head locking knobs.
5. Repeat this adjustment procedure on the opposite end of the outfeed roller.
HOW TO ADJUST THE TENSION OF THE INFEED AND OUTFEED ROLLERS
The infeed and outfeed are under spring tension. The
tension should be sufficient to feed the stock uniformly
without slip ping, but should not be so tight that it causes
damage to the board. The tension should be equal at
both ends of each roller.
To adjust the spring tension of the infeed roller, turn two
screw is located on the opposite side of the machine.
FOUR threads show
above the table casting. Further tension adjustment may
be necessary.
To adjust the spring tension of the outfeed roller, turn two
screw is located on the opposite side of the machine.
ONE thread shows above
the table casting. Further tension adjustment may be
necessary.
A
E
D
C
HOW TO ADJUST THE HEIGHT OF THE OUTFEED ROLLER
A
B
Fig. 52
Disconnect the machine from the power source.
The outfeed roller was adjusted at the factory to be 0.040" (1.01 mm) below the cutting circle. To check and adjust
the height of the outfeed roller:
A
C
E
D
Fig. 53
Fig. 54
A
B
Fig. 55