Filter
Top Products
6
ATTACHING MOTOR PULLEY
Attach the motor pulley (A) Fig. 7 to the motor shaft, making
sure that the set screw (B) in the motor pulley engages with
the key (C) in the motor shaft. NOTE: The key (D) Fig. 5 is
shipped taped to the motor. Remove it, place it on the motor
shaft, and attach the pulley over it.
Fig. 7
A
B
C
ASSEMBLY
STAND
The stand is shipped top-down in the shipping container
with the motor mounted to the inside top of the stand. The
on/off switch is wired to the end of the power cord.
To make the motor operational, do the following:
1. Remove the stand (A) Fig. 4 from the shipping container.
NOTE: Set the stand on several blocks of wood to raise the
stand off the floor.
2. Take the panel (B) Fig. 4 off of the stand (A) by removing
two screws (C) and loosening the two other screws (D).
Remove the panel on the opposite side of the stand in the
same way.
Fig. 4
Fig. 5
3. Remove the two mounting screws that are holding the
motor (F) Fig. 5 to the top of the stand. One screw is shown
at (E) Fig. 5.
4. Remove motor from stand.
Fig. 6
ATTACHING MOTOR TO STAND
1. Turn the stand on its side with the two bars (B) Fig. 6
down.
2. Position the motor (C) Fig. 6 on the two horizontal sup-
port bars (B), and fasten with the four 5/16x18 carriage bolts
and flange nuts, three of which are shown at (F). IMPOR-
TANT: PLACE THE MOTOR SHAFT (E) ON THE SAME
SIDE OF THE STAND AS THE LARGE OPENING AT THE
TOP OF THE STAND (SEE (B) FIG. 8) BEFORE LOOSELY
TIGHTENING THE CARRIAGE BOLTS (F). Further align-
ment will be necessary after the saw is attached to the
stand.
3. Carefully turn the stand right side up.
A
B
C
D
F
E
C
F
E
B
F
D