Filter
Top Products
8
Fig. 17
Fig. 18
STARTING AND STOPPING SAW
To start the tool, press the “START” button (K) Fig. 17. To stop the tool, press the “STOP” button (L) Fig. 17.
LOCKING SWITCH IN THE OFF POSITION
IMPORTANT: When the tool is not in use, the switch should be locked in the “OFF” position to prevent unau-
thorized use, using a padlock (M) Fig. 18 with a 3/16" diameter shackle.
Fig. 15
Fig. 16
E
E
F
K
5. Use the two nuts and lockwashers (E) Fig. 14, removed in
STEP 3, to fasten the switch box to the bandsaw arm (Fig. 14).
6. Remove the screw (F) and cable clamp (E) Fig. 15 from the
lower arm of the band saw.
7. Insert the switch cord and power cord (F) Fig. 16 into the
clamp (E) (removed in STEP 6), and fasten to the bandsaw.
8. Push connector end of switch cord through the plastic
bushing (G) Fig 16A. and plug it into the motor cord.
IMPORTANT: Be certain to prevent contact between the
switch-to-motor cord (F) Fig. 16 and the motor pulley or belt.
If necessary, adjust the cord, then tighten the cable tie (H)
Fig.11.
9. Attach the two side panels removed earlier.
Fig. 14
E
Fig. 19
A
B
TABLE INSERT
Place the table insert (A) Fig. 19 in the hole provided in the
table. Engage the protrusion on the insert in the indent (B) in
the table.
L
M
Fig. 16A
F
G