Filter
Top Products
23
ATTACHING THE ACCESSORY 33-967 MOULDING CUTTERHEAD GUARD
Use the molding cutter guard on all molding operations.
Disconnect the machine from the power source!
1. Remove the blade and blade guard assembly.
2. Move the motor so that the arbor is in the down position (Fig. 58).
3. Place the guard (A) Fig. 58 on the motor with the stud on the motor inserted through the hole in the guard. Thread the
special nut (B) on the motor stud and fasten with a screwdriver (Fig. 58).
4. Position the motor as shown in Fig. 59. Adjust the height of the guard (A) Fig. 58 by loosening the three screws (C).
Fig. 58
A
B
MACHINE USE
Fig. 59
C
To reduce the risk of injury, turn unit off and disconnect the machine from the power source before
installing and removing accessories, before adjusting or changing set-ups, or when making repairs. An accidental
start-up can cause injury.
Before connecting the radial arm saw to the power source or operating the saw, always inspect the
guard and splitter for proper operation alignment and clearance with the saw blade. Personal injury may result.
CROSS-CUTTING
To reduce the risk of injury, turn unit off and disconnect the machine from the power source before
installing and removing accessories, before adjusting or changing set-ups, or when making repairs. An accidental
start-up can cause injury.
NEVER touch the "free end" of the workpiece or a "free piece" that is cut off while the power is "ON"
and/or the saw blade is rotating. The piece may contact the blade resulting in a thrown workpiece and possible injury.
Use caution when starting the cut to prevent binding of the guard against the workpiece resulting in
damage to the saw and possible injury.
Before using the saw, verify the following each and every time:
1. ALWAYS wear proper eye, hearing and respiratory equipment.
2. Blade is tight.
3. Bevel angle and height lock knobs are tight.
4. If ripping, ensure fence lock lever is tight and fence is parallel to the blade.
5. If crosscutting, miter gauge knob is tight.
6. The blade guard is properly attached and the anti-kickback teeth are functioning.
7. ALWAYS inspect the guard and splitter for proper alignment operation and clearance with saw blade.
Failure to adhere to these common safety rules can greatly increase the likelihood of injury.