Filter
Top Products
7
ASSEMBLY
Fig. 4A
ASSEMBLING
STEEL LEGS TO BASE
Carefully support the machine to the rear and brace the
frame so the machine is balanced. Attach the four steel
legs to each end of the base using sixteen 5/16-18x5/8"
carriage head screws (A) Fig. 4A and Fig. 4B, 5/16" flat
washers (B), 5/16" lockwashers (C) and 5/16" hex nuts
(D). Return saw to upright position.
Fig. 5
Fig. 6
ASSEMBLING OVERARM
ELEVATING HANDLE
1. Insert roll pin (A) Fig. 5, into the hole in elevating
shaft (B).
2. Line up the slots in elevating handle (C) Fig. 5, with
roll pin (A) and place handle on shaft (B) making certain
the roll pin is engaged in the slots.
3. Fasten elevating handle (C) Fig. 6, to shaft (B) with
a 1/4-20X1/2" hex head screw (D) and 1/4" flat washer
(E).
A
B
C
Fig. 4B
A
B
C
D
A
B
C
D
B
C
D
E