17
3. Before tightening the hardware holding the guide rail
to the saw table, proceed as follows: Beginning at the
two sides of the saw table and using an adjustable
square (F) Fig. 41, or a ruler, check to make certain the
guide rail (A) is parallel with the saw table and extension
wings. Tighten all guide rail mounting hardware.
4. Insert end cap (G) Fig. 42, onto each end of the
guide rail (D) as shown. Using a block of wood and
hammer, gently tap end caps until they are completely
seated into each end of the guide rail. NOTE: Do not use
a hammer directly against the end caps, this could
cause damage to the aluminum rail.
5. Align holes in saw table and extension wings with
four holes in rear guide rail (J) Fig. 43. NOTE: Flat edge
of rear guide rail (J) will face upward. Insert a 3/8-16x1"
hex head screw (A) Fig. 43, through hole in rear guide rail
and hole in saw table. Place a 3/8" flat washer (B) Fig.
43, and a 3/8" lock washer (C), onto the hex head screw.
Thread a 3/8-16 hex nut (D), onto the hex head screw.
Repeat this process for the three remaining holes in the
rear guide rail and the saw table and extension wings.
6. Before tightening mounting hardware, using an
adjustable square (F) Fig. 44, or a ruler, check to make
certain the rear guide rail (J) is parallel with the saw table
and extension tables.
GUIDE RAILS AND
SWITCH ASSEMBLY
1. Loosely assemble front guide rail (A) Fig. 40, to the
front of the saw table. Align the two holes (B) and (C)
with the two holes in the saw table. Insert a 3/8-16x1-
1/2" flat head screw (F) Fig. 40, through holes (B) and (C)
in the front guide rail (A) and the holes in the front of the
saw table. Place hole in switch bracket (E) Fig. 40, on
screw (B) located behind the inner lip of the saw table.
Place a 3/8" flat washer (G) and a 3/8 lockwasher (H),
onto the flat head screw (F). Thread a 3/8-16 hex nut (J),
onto the flat head screw (F). Repeat this process for the
remaining hole (C) in the guide rail and the saw table.
2. Loosely fasten guide rail (A) Fig. 41, to the left and
right extension wings. Align the the hole (B) Fig. 41, in
the left side of the guide rail with the hole on the left
extension wing. Insert a 3/8-16x1-1/2" flat head screw
through the hole (B) in the front guide rail (A) and the hole
in the front of the left extension wing. Place a 3/8" flat
washer and a 3/8 lockwasher onto the flat head screw.
Thread a 3/8-16 hex nut onto the flat head screw.
Repeat this process for the remaining hole in the guide
rail and the right extension wing.
Fig. 40
J
H
G
F
B
E
D
A
C
Fig. 41
F
A
B
Fig. 42
G
Fig. 43
A
B
C
D
Fig. 44
F
J
J
D