Filter
Top Products
ASSEMBLY
STAND LEGS
1. Assemble the longer bottom bracket (A) Fig. 6, to
the inside of two table legs (B) as shown. Align the holes
in the longer bottom bracket (A) Fig. 6, with the holes in
the table legs (B). Insert a 5/16-18x5/8" carriage head
bolt through the hole in the table leg (B) and the hole in
the longer bottom bracket (B), place a 5/16" flat washer
onto the carriage head bolt, place a 5/16" lockwasher
onto the carriage head bolt, thread a 5/16-18 hex nut
onto the carriage head bolt. NOTE: Only snug-up stand
mounting hardware at this time. Repeat this process for
the three remaining holes in the larger bottom bracket.
2. Assemble the other stand bracket (A) Fig. 6, to the
remaining two table legs (B) in the same manner.
3. Assemble the two shorter stand brackets (D) Fig. 7,
to the leg assemblies (B) in the same manner as the
longer bottom bracket was assembled.
4. Assemble a rubber foot (E) Fig. 7, to the bottom of
each leg as shown.
Fig. 6
Fig. 7
Fig. 8
8
B
B
A
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
Fig. 9
H
D
D
D
B
E
D
B
STAND TO SAW
TO PREVENT PERSONAL INJURY OR
DAMAGE TO THE MACHINE, WE SUGGEST THAT THE
STAND BE MOUNTED TO THE SAW AS FOLLOWS:
1. Place the saw upside down on a sturdy work bench
or floor as shown in Fig. 8. TO PROTECT
THE TABLE TOP, PLACE SOMETHING BETWEEN
THE TABLE TOP AND THE WORK BENCH OR
FLOOR, SUCH AS A PIECE OF CARDBOARD,
CARPET ETC. NOTE: Make certain the shorter stand
brackets (D) Fig. 8, are at the front and rear of the saw
as shown.
2. Align the eight holes in the bottom of the saw
cabinet with the eight holes in stand legs. Place a 5/16"
flat washer onto a 5/16-18x5/8" hex head screw. Insert
the hex head screw through the hole in the saw cabinet
and the hole in the stand leg. Place a 5/16" flat washer
onto the hex head screw, place a 5/16" lockwasher onto
the hex head screw, thread a 5/16-18 hex nut onto the
hex head screw. NOTE: Only snug-up stand mounting
hardware at this time. Repeat this process for the five
remaining holes in the saw cabinet and the stand legs.
3. Assemble bracket (H) Fig. 9, to the inside of front leg
assembly (D) as shown. Align holes in bracket (H) with
holes in front leg assembly (D). Place a 5/16" flat washer
onto a 5/16-18x5/8" hex head screw. Insert the hex
head screw through the hole in the saw cabinet, stand
leg, and bracket (H). Place a 5/16" flat washer onto the
hex head screw, place a 5/16" lockwasher onto the hex
head screw, thread a 5/16-18 hex nut onto the hex head
screw. NOTE: Only snug-up stand mounting hardware
at this time.