Filter
Top Products
13
ALTERNATE ASSEMBLY ARRANGEMENT
To assemble the Versa-Feeder
TM
in the mounting arrangement shown in Fig. 4, attaching the pivot ball to the overarm
clamp assembly differs slightly. To assemble:
1. Remove the overarm (A) Fig. 24 from the overarm clamp assembly (B).
2. Remove the swivel joint (C) Fig. 24 and mounting bracket (D) from the clamp assembly (B).
3. Remove the overarm (A) Fig. 25 from the housing (E).
4. Remove the pivot ball (F) Fig. 26 from the angled end of the overarm (A).
5. Insert the long end of the overarm (A) Fig. 27 into the overhead clamp assembly (B) until the gear inside the clamp
assembly meshes with the rack on the overarm. Turn the handle (G) Fig. 28 clockwise to move the overarm (A) into
the clamp assembly (B).
IMPORTANT: Depending on the application, you can insert the overarm (A) Fig. 28 into either end of clamp
assembly (B).
Fig. 24
Fig. 25
Fig. 26
Fig. 27
Fig. 28
A B
C
D
E
A
A
F
A
B
B
A
G