Filter
Top Products
9
ASSEMBLY
ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE
3/8" Wrench
5/16" Wrench
7/16" Wrench
1/2" Wrench
4mm Hex Wrench
Phillips Screwdriver
Approximately 2-4 hours
The Versa-Feeder
TM
can be assembled as shown in Figs. 3 or Fig. 4, depending on the operation and type of wood-
working machine on which the stock feeder will mount. The following instructions pertain to the assembly in Fig. 3.
IMPORTANT: Familiarize yourself with the following assembly instructions and the components of the machine. If you
wish to assemble the stock feeder in the arrangement shown in Fig. 4, minor variations in the assembly instructions
are detailed on page 13.
Fig. 3
Fig. 4
1. Attach the pivot ball (A) Fig. 5 on the end of the overarm (B) with a 3/8" lockwasher (C) and 3/8-16 x 1" hex head
screw (D). Tighten with the supplied hex wrench (E) Fig. 6.
NOTE: Make certain that the screw (C) and lockwasher are recessed inside the pivot ball (A) Fig. 6.
AB
C D
C
E
Fig. 5
Fig. 6