Filter
Top Products
14
6. Insert the straight end of the overarm (A) Fig. 29 through the housing (E). Attach the pivot ball (F) Fig. 29 to the over-
arm (A) with a 3/8-16 x 1" socket hex head screw and lock-washer (K) Fig. 30.
NOTE: Make certain that the screw and lockwasher (K) are recessed inside pivot ball (F).
7. Push the pivot ball, attached to the overarm (A) Fig. 31, to the front of the housing (E). Place the cover (M) over the
pivot ball (F) with the wider slots of the cover (M) positioned horizontally. Insert the metal shaft (N) Fig. 32 through
the hole in the side of the sleeve (P) and the wide slot of the cover (M). Fasten in place with the T-handle screw (R)
Figs. 32 and 33.
8. Re-attach the overarm and feeder assembly (S) Fig. 34 to the swivel joint (C) and the mounting bracket (D). Fig. 34
illustrates the stock feeder assembled in the alternate mounting arrangement.
Fig. 29
Fig. 30
Fig. 31
Fig. 32
Fig. 33
Fig. 34
A
E
K
F
F
K
A
E
M
F
E
A
P
N
R
M
R
S
C
D