Filter
Top Products
17
When you use the sanding arm (A) Fig. 31 in the vertical position, you can move the complete table assembly (B) from
the disc unit to the belt unit.
Two holes are provided in the base casting to store the
two wrenches (A) Fig. 33, supplied with the sander.
USING THE TABLE ASSEMBLY WITH THE SANDING ARM
DISCONNECT MACHINE FROM POWER SOURCE.
1. Remove the backstop (C) Fig. 31.
2. Thread the M8 x 1.25 x 20mm hex socket head screw (D) Fig. 31 ONLY PART OF THE WAY into the base casting.
3. Loosen the screw (E) Fig. 31, and remove the table assembly (B) from the disc unit. Insert the bar (F) into the hole
(G) on the belt unit. Align the flat on the shaft with the screw in the casting and tighten the screw.
Fig. 31
C
A
D
G
E
F
B
To avoid trapping the work or fingers between the backstop and the sanding belt, the edge of the
table (A) Fig. 32 should be positioned a maximum of 1/16" away from the sanding belt (B).
Fig. 32
B
A
WRENCH STORAGE
Fig. 33
A