Filter
Top Products
5
ASSEMBLY
ASSEMBLING WHEEL
CASTERS
1. Remove the hex nut and lockwasher from each of
the four wheel casters.
2. Place the dust collector on its side.
2. Insert bolt from wheel caster through the four holes
(A) Fig. 3 in the base of the dust collector.
3. Place a lockwasher (A) Fig. 4 onto each bolt.
4. Thread hex nut (B) Fig. 4 onto each of the four bolt
heads and tighten securely.
ASSEMBLING OUTTAKE
FLANGE
1. Align the holes in the outtake flange (A) Fig. 5 with
the holes in the outtake flange gasket (B).
2. Insert a 5/16-18x5/8" hex head bolt thru the outtake
flange, outtake flange gasket and the base unit as
shown in Fig. 6.
3. Thread a 5/16” hex nut (B) onto the 5/16-18x5/8"
hex head bolt (A) Fig. 6 and tighten securely.
4. Repeat this process for the three remaining bolts.
Fig. 3
A
Fig. 4
A
B
Fig. 5
A
B
Fig. 6
A
B