Filter
Top Products
8
Fig. 10
Fig. 11
Fig. 12
Fig. 13
ASSEMBLING FILTER
AN D DUST COLLECTION
BAGS TO DRUM
1. Thread 5/16 hex locknut (A) Fig. 10, onto the end
of bag support rod (B). Place lockwasher and flat wash-
er (C) Fig. 10, onto bag support rod (B). Thread rod into
hole (D) and tighten locknut (A) against motor and blower
assembly (E) to hold support rod (B) upright. Height of
support rod can be adjusted after the filter bag is in place.
2. Hook the loop on the top of filter bag (F) Fig. 1 1, onto
the end of support rod (B).
3. Position open end of filter bag (F) Fig. 1 1, over the lip
of drum (G). NOTE: It may be necessary to adjust the
height of the drum support rod at this time. If adjustment
is necessary, loosen locknut (A) Fig. 11, and rot ate
support rod (B) as needed to obtain proper rod height to
support filter bag (F). T ighten locknut (A) Fig. 11. Insert
locking band (H) through the hem of filter bag (F) and
fasten filter bag to drum by locking clamp (J) as shown
in Fig. 12. IMPORTANT:Make certain band (H) is
positioned in the channel of drum (G) before locking
clamp (J).
4. Insert remaining locking band (H) Fig. 13, through
hem of dust collection bag (K). Position open end of bag
over the lip of drum (G) and fasten with locking clamp (J).
NOTE: Make certain locking band (H) is positioned in the
channel of drum before locking clamp (J).
E
C
D
B
A
B
F
G
H
A
H
J
G
G
H
J
K