Filter
Top Products
6
N
FIG. 4
H
M
O
M
Q
S
O
U
P
Adjusting Blades (Fig. 5)
1. Place the blade (O) on the gauge (R), and make sure the blade edge is perfectly
flush with the inside edge of the gauge (R).
2. Place the bracket (S) on the blade, and make sure the flange of bracket is flush
with the back side of the gauge.
3. Tighten the two screws (T) on the bracket.
4. Place the flange of the bracket into the groove of drum (U).
5. Replace the drum cover (Q) and tighten the three bolts (M).
O
T
R
M
Q
S
O
U
T
S
FIG. 5
Sharpening Blades (Fig. 6)
V
FIG. 6
O
1. Fasten the blade to the sharpening holder (V).
Make sure both blade edges are facing the
same direction.
2. Place the blade edges so they rest flat on the
grinding stone.
3. Firmly grip the sharpening holder and move it
back and forward to sharpen the blade (O).
OPERATION
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
NOTICE: Risk of property damage. Use sharp blades only.
PRIOR TO OPERATION:
• Adjust the depth of cut.
• Fit and adjust the parallel fence, if needed.
Switch (Fig. 1)
WARNING: Check that the tool is not locked on before connecting it to a power
supply. If the trigger switch is locked on when the tool is connected to the power
supply, it will start immediately. Damage to your tool or personal injury may result.
CAUTION: Risk of property damage. Allow the tool to reach full speed before
touching tool to the work surface. Lift the tool from the work surface before turning
the tool off.
To start the planer depress the trigger switch (A). To turn the planer off, release the
trigger switch.
LOCK-ON BUTTON
The tool can be locked on for continuous use. To lock the tool ON depress the trigger
switch (A) and push in the lock-on button (B). Hold the lock-on button in as you
gently release the trigger switch. The tool will continue to run.
To turn the tool off from a locked-on position, squeeze and release the trigger once.