Open as PDF
• Do not disassemble the charger; take it to an authorized
service center when service or repair is required. Incorrect
reassembly may result in a risk of electric shock, electrocution or ﬁre.
• Disconnect the charger from the outlet before attempting
any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard 120 V
household electrical power. Do not attempt to use it on any
other voltage. This does not apply to the vehicular charger.
Your tool uses a D
WALT charger. Be sure to read all safety instructions
before using your charger. Consult the chart at the end of this manual
for compatibility of chargers and battery packs.
Charging Procedure (Fig. 1)
1. Plug the charger into an
appropriate outlet before
inserting the battery pack.
2. Insert the battery pack (K)
into the charger, as shown in
Figure 1, making sure the pack
is fully seated in charger. The
red (charging) light will blink
continuously, indicating that the
charging process has started.
3. The completion of charge will be indicated by the red light
remaining ON continuously. The pack is fully charged and may be
used at this time or left in the charger.
Indicator Light Operation
DCB101, DCB102, DCB103
PROBLEM PACK OR CHARGER
DCB107, DCB112, DCB113, DCB115
This charger is designed to detect certain problems that can arise.
Problems are indicated by the red light ﬂashing at a fast rate. If this
occurs, re-insert the battery pack into the charger. If the problem
persists, try a different battery pack to determine if the charger is
working properly. If the new pack charges correctly, then the original
pack is defective and should be returned to a service center or other
collection site for recycling. If the new battery pack elicits the same
trouble indication as the original, have the charger and the battery pack
tested at an authorized service center.