Filter
Top Products
12
TILTING THE TABLE
Disconnect machine from power source.
The table on your scroll saw can be tilted 45° to the left for
bevel cutting operations by removing the dust cup as shown
in Fig. 24 and loosening table lock knob (A) Fig. 10, tilt the
table to the desired angle indicated on degree scale (B) Fig.
11 and tighten lock handle (A) Fig. 10.
When bevel cutting, the holddown (B) Fig. 12, can be
adjusted to lay flat on the stock by loosening screw (C) and
tilting the holddown (B). Then tighten screw (C).
ADJUSTING THE TABLE
Disconnect machine from power source.
1. Loosen table lock knob as shown in Fig. 10 and move
the table all the way to the right until angle indicator
shown in Fig. 11 is on "0".
2. Using a square that includes a level, check to see if the
table is level (A) Fig. 13, and is 90° to the saw blade (B),
as shown.
3. If the table is not at 90° to the blade, adjust the table
making certain screw (B) Fig. 14, contacts bottom of
table surface when table is 90° to the blade. To make
this adjustment loosen nut (C), turn screw (B) in or out
the desired distance and tighten nut (C).
NOTE: After adjusting table, reposition the pointer (B) Fig.
11 to "0" degrees. Loosen the screw (A) Fig. 11 and adjust
pointer (B) to "0" degree mark and retighten screw (A).
A
Fig. 10
Fig. 11
A
B
Fig. 12
B
C
Fig. 14
B
C
Fig. 13
B
A