Filter
Top Products
36D-Link DNS-343 User Manual
Section 3 - Configuration
FTP Server
FTP Server
Settings
The DNS-343 is equipped with a built in FTP Server. The server is easy to configure and allows up to 10 users to access the server locally
or remotely at the same time.
This section contains the configuration
settings for the DNS-343 FTP Server.
Determines whether the FTP server rule will
apply to an individual user or a group.
Select the group or user the FTP server rule
will apply to.
Browse to and select the folder or directory
you are granting FTP access to. Select root
to grant access to all volumes.
Set the user or group permission to Read
Only or Read/Write.
Sets the maximum amount of users that can
connect to the FTP server.
Sets the amount of time a user can remain
idle before being disconnected.
Sets the FTP port. Default is 21.
Allows you to limit the amount of bandwidth available for each user.
Specify alternate input characters allowed for FTP connection requests.
Category
User / Group
Folder
Permission
Max User
Idle Time
Port
Flow Control
Client Language
Note: If your Internet access is controlled through a router, or if your network uses a firewall device of any kind, it will likely be necessary to configure the router or
firewall device to allow FTP requests from the Internet. Often it is possible to configure the router to direct FTP traffic to specified devices, in this case, to the DNS-343.
Usually, at a minimum, it is necessary to enter the IP address of the DNS-343 and the TCP port used for FTP (port 21). See the user documentation of the firewall
device or router for information on creating forwarding rules for FTP traffic to devices on the LAN.
FTP Server Settings