Filter
Top Products
-16-
" " #""#
The Dremel SM20, Miter/Trim Cutting Guide
(Optional Attachment) and Flush Cutting
Wheel is a perfect combination to make miter,
bevel, and straight cuts in baseboard, trim,
and molding. Angle indicators also aid in
making accurate cuts for other common
angles like 15°, 22.5° or 30°.
1. Measure and mark the desired cut line on
the piece of wood.
2. Position the Miter/Trim Cutting Guide over
the wood in the designated location of the
cut.
3. Clamp the cutting guide to the workpiece in
the desired location to make the cut.
4. Firmly hold the tool and make the cut.
Straight Cuts- use the outside edge of the
cutting guide as the fence, (Fig. 17)
45° Miter Cuts- use the angled edge of the
cutting guide as the fence, (Fig. 18).
Ensure the tool is properly
seated in the guide before
starting the tool and use caution when
stopping the tool within the cutting rail to
ensure that the cutting wheel does not come
into contact with the cutting guide.
Miter Cuts (15°, 22.5° or 30°)- Pivot the cutting
guide at the designated corner to the desired
angle using the angle indicator marking on the
cutting guide, complete the cut using the
outside edge of the cutting guide as the fence,
(Fig. 17).
45° Bevel Cuts- While using the flush cutting
wheel only
, place the saw in the cutting rail to
complete the cut, (Fig. 19).
The guide positions the saw to make bevel
cuts in workpieces up to 9/16" thick. To make
a cut, first position the tool into the rail so the
back of the tool’s foot fits into the keying
feature. Switch on the tool and proceed to
make the cut. Stop the tool before removing
from guide.
Determine if a Inside Left, Outside Left, Inside
Right, or Outside Right cut is required and
orient the workpiece. Positions A, B, C, or D.
FIG. 17
FIG. 18
FIG. 19
!
WARNING
DM 2610013190 06-11:DM 2610013190 06-11.qxp 6/6/11 10:43 AM Page 16