Filter
Top Products
SAFETY PRECAUTIONS
Please familiarize yourself with the following information to prevent
damage to your compressor unit and injury to the operator.
CAUTIONS
The air compressor motor and/or engine will get hot while in operation.
Never touch the discharge tubing,engine,motor or compressor pump while in
operation. The compressor operates automatically while the power is
connected and turned on,or the engine is running.
Compressed air from the unit may contain hazardous fumes. Air produced by
this compressor is not suitable for breathing purposes. Always use a respirator
when spraying paint or chemicals,or when sandblasting. Always wear safety
glasses or goggles when using compressed air.
It is not practical or possible to warn you about all the hazards associated with
operating or maintaining this equipment. You must use your own good
judgment.
EXTENSION CORDS
Make sure your extension cord is in good condition.When using an extension
cord,be sure to use one heavy enough to carry the current your product will
draw.An undersized cord will cause a drop in line voltage resulting in loss of
power and overheating.Table 1 shows the correct size to use depending on
cord length and nameplate amperage rating.If in doubt, use the next heavier
gauge.The smaller the gauge number, the heavier the cord.
Table 1 — Minimum Gauge for Cord
Ampere Rating
Volts Total length of cord in feet
120 V 25 ft. 50 ft. 100 ft. 150 ft.
More than Not more than AWG
0 6 18 16 16 14
6 10 18 16 14 12
10 12 16 16 14 12
12 16 14 14 Not Recommended
AIR RECEIVER
Over pressurizing the air receiver could cause personal injury or material
damage. To protect from over pressurizing,a factory pre-set safety valve is
installed.
2